Chell produces a range of digital displays that would suit most applications. These displays can be used with a variety of transducers including, capacitance manometers, flow meters and flow controllers. In fact any transducer with a +/15 or +24v power supply and a 5 or 10 volt DC output can be accommodated.

Please use the selection table to below to identify the display that is most suitable.

• Fully integrated 5 digit display and power supply for a wide choice of gas mass flowmeters, gas flow controllers, capacitance manometers and all-media pressure transducers.
• RS232, RS485 and analogue interfaces as standard.
• Setpoint input for ‘slaved’ commands.
• +/- 15 volt and 24 volt transducer supply
• 16 bit resolution, 0.02% of reading accuracy.
• 0-5 volt set point output programmed from front panel or digital comms.
• Aluminium case for bench top use or panel mounting (1/8 DIN)
• Two programmable alarm outputs (mechanical volt free changeover contacts).
• Display can be zeroed from the front panel or remotely.
• Ethernet interface available.
  

• Fully integrated 5 digit display and power supply for a wide choice of gas mass flowmeters, capacitance manometers and all-media pressure transducers.
• Display can be calibrated (with linearisation) to display units of choice.
• Digital communications via RS232, RS485 and DeviceNet available.
• +/- 15 volt , 500mA transducer supply.
• Totalising function as standard.
• Two set-point alarm outputs available.
• 16 bit resolution, 0.03% of reading accuracy.
• Voltage and current measurement versions available.
• Re-transmitted analogue output (after linearisation) available.

• Any of the analogue input channels can be configured and linearised to display units of choice.
• Process controller complete with self learning PID.
• Supplied with software to allow configuration and data reading on a PC.
• Networkable digital communications via Ethernet, also RS232 and RS 485
• +/- 15 volt 250mA or +24 volt 250mA transducer supplies
• 16 bit resolution, 0.05 % reading accuracy
• Voltage and current input versions available
• Configurable voltage and current analogue retransmission, after linearisation

• 20 channels of voltage input - supports heated capacitance manometers, mass flow meters and mass flow controllers.
• Networkable digital communications via Ethernet, also RS232 and RS485
• +/- 15 volt transducer supplies
  
• User settable units and ranges.
• Supplied with software to allow configuration and data reading on a PC.
• 1All 20 channels can be displayed on screen (scrollable) - possible to operate from the front panel or via comms.
• Channels 2-20 can be slaved from channel 1.